Current release is version 1.0 and was published 2002-05-07
Older releases are listed in the download section, their documentation is not
online but is included in the archive.
Requirements
The driver has been tested to work with the following environment:
SuSE 7.1
Kernel 2.4.18
XFree86 4.2
They should also run with
any other distribution
Kernel 2.4.x
Kernel 2.2.x
XFree86 3.3.6
It will most likely compile with any other kernel of the 2.4`er series. Support for
2.2.x kernels and for XFree86 3.3.6 was added after some contributions made by
Jonathan Germain (Thank's again!), but have not been testet, yet.
In case the driver won't work on these systems, you can download Jonathan's contributed
driver below.
Replaced the mode parameter. There are now three different
device nodes, one for each output format. With that, it is possible
to uses all modes simultanously.
Added support for simple calibration. You can specify screen dimension
and physical coordinate ranges as module parameters.
Improved SUMMA emulation. The resolution can now be set by the client
and is correctly evaluated. This should hopefully add support for
XFree 3.3.6. ( untested )
This version was contributed by Jonathan Germain, the
changes he made were merged into release 1.0. As they are currently
untested in that version, we provide the original here as well.
This release should work with kernel 2.2 and kernel 2.4, but it will
only work with xfree 3.3.6, and not with xfree 4.2!